EasyManuals Logo

Jacuzzi J-585 User Manual

Jacuzzi J-585
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Page 18
!
WARNING: TO DECREASE RISK OF INFECTION OR
DISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne
illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments
. Fill until water covers all jets but does not
touch the bottom of the lowest headrest (DO NOT OVERFILL!).
IMPORTANT: Always ll your spa through both lter ttings after
draining. Failure to do so may cause air to be trapped in the pumps,
preventing them from circulating water. Remove the hose and
replace both lter cartridges as illustrated in Section 13.1 (page
51).
3. Turn On Power
Turn on power to spa at the home’s circuit breaker. The heater
and lter/circulation pump will automatically activate. If the screen
displays either a “Cool Warning” or “Freeze Protection” error, this is
normal. Normally, at the initial ll, the water tends to be cold. Refer to
page 66 for additional information.
4. Activate Jets Pumps
Turn on jet pumps when adding chemicals in step 5
(see Section 11.2, page 32 to activate jets).
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi spa dealer. See Section titled “Water Quality Maintenance”
(page 59) for general guidance.
WARNING: RISK OF POISONING OR DEATH.
Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendor’s instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.
!
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 1.0 ppm free
chlorine or 2.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended on the inside cover of this manual. If sanitizer levels
cannot be stabilized, perform the decontamination procedure steps
1-7 on the following page.
Note: The “Decontamination Procedure” should also be used after the
spa has been “Winterized” (Sec. 13.8, page 58) or has been sitting
without power for an extended period.
1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi J-585 and is the answer not in the manual?

Jacuzzi J-585 Specifications

General IconGeneral
BrandJacuzzi
ModelJ-585
CategoryHot Tub
LanguageEnglish

Related product manuals