Page 42
During a primary ltration, the circulation pump, CLEARRAY and ozone
unit (if applicable) are activated. The factory default cycle starts at 12:00
AM and last for 8 hours. If you elect to keep this setting, then you can
skip this section.
In extreme bitter cold weather we recommend you program
the circulation pump to run 24 hours. Refer to the "Winterizing"
section on page 58.
Any time the circulation pump runs outside of a program cycle, e.g. for
heating, that run time will be deducted from the next primary lter cycle.
For example, the primary lter cycle is set to 8 hours every 24 hours but
the circulation pump comes on for 2 hours to heat the water after the
cycle has nished. The next primary lter cycle will only be for 6 hours
not 8 hours.
A. To change the default cycle (the
adjustments are made in 1-hour
increments):
1. Tap
to program the start time for
the cycle.
2. Slide your nger up and down to roll
the time scroll wheels to adjust the start
time.
3. Tap
to program the end time for the cycle.
4. Slide your nger up and down to roll the time
scroll wheels to adjust the end time.
5. Tap
to save and accept the changes.
Summer Logic: In warm weather, the water temperature in the spa
may exceed the set temperature. This condition may occur due to
heat transference from the lter/circulation pump and jets pumps.
If the water temperature is higher than 95°F (35°C) and rises two
degrees above the set temperature, a “Summer Logic” condition
occurs that deactivates the lter/circulation pump and CLEARRAY®.
This safety feature cannot be altered! The lter/circulation pump and
CLEARRAY® will remain off until the water temperature cools to the
set temperature (except between 9am-11am when the lter/circulation
pump runs for it’s mandatory 2 hour cycle.) To help prevent a “Summer
Logic” condition, it may be necessary to reduce lter/circulation pump
cycles run times in warm weather.
Primary Filter
12:00
Start
Set
8 00
8:00
End
pm
Figure 12.2c
To Next Page
Loading...
Need help?
General
