Page 45
B. Programming the ProClarity/ProClear Filter Timer
A programmable lter timer can be set to remind you when to clean or
replace the lters and skimmer bag.
1. When you enter the “Water Care”
Menu, Figure 12.6c, tap
>
or
>
until you
reach the “ProClarity” option, Figure
12.6d.
2. Slide your nger up and down to roll
the days scroll wheel to adjust the
number of days from OFF to 180. The
adjustments are made in increments of 10 days. The
days are stored in memory if the power is interrupted.
Note: It is not recommended that this feature be turned OFF. In order to
continually maintain clean and working lters, it should be program as
instructed.
3. Tap
to conrm and save your changes.
4. When the timer expires, a message will appear on the control panel
display, page 67. The lters must be cleaned or replaced. Follow
the instructions above to reset the timer. If you tap “snooze” the
message will clear but the error icon will display and the reminder
screen will reappear in 10 days. Refer to Section 13.1, page 51,
for cleaning instructions.
C. Programming the ProClarity Depth Filter Timer
A programmable lter timer can be set to remind you when to replace the
ProClarity Depth Filter.
1. When you enter the “Water Care”
Menu, Figure 12.6d, tap
>
or
>
until you
reach the “ProClarity Depth” option,
Figure 12.6e.
2. Slide your nger up and down to roll
the days scroll wheel to adjust the
number of days from OFF to 90. The
adjustments are made in increments
of 10 days. The days are stored in memory if the
power is interrupted.
Note: It is not recommended that this feature be turned OFF. In order to
continually maintain clean and working lters, it should be program as
instructed.
3. Tap
to conrm and save your changes.
4. When the timer expires, a message will appear on the control panel
display, page 67. Follow the previous instructions to reset the
timer. The lter must be replaced. Refer to Section 13.1, page 51,
for lter location. If you tap “snooze” the message will clear but the
error icon will display and the reminder screen will reappear in 10
days.
Water Care
set to
180
0 days
Set
>
ProClarity
>
Figure 12.6d
Water Care
set to
90
0 days
ProClarity Depth
>
Set
>
Figure 12.6e