Page 67
15. Watchdog Freeze Protection: Spa water is below 40°F/4.4°C. Jet
pumps operate until the spa is out of danger. Contact your authorized
dealer or service organization.
Note: The heater icon
ON
will be blinking and the error icon will be
displayed under the temperature.
16. Controller Overheat Protection: Controller temperature has exceeded
acceptable limits. If condition persists, provide shade for equipment
side of spa. Contact your authorized dealer or service organization.
Note: The heater icon
ON
will be blinking and the error icon will be
displayed under the temperature.
17. Panel Com Error: The topside controller is having trouble
communicating to your spa. Contact your authorized dealer or
service organization.
18. Stereo Com Error: The stereo is having trouble communicating to
your spa. Contact your authorized dealer or service organization.
19. CLEARRAY Replacement Reminder
This message will appear when the CLEARRAY
bulb reminder time has expired (Figure 15.0d).
The CLEARRAY bulb must be replaced.
20. ProClarity/ProClear Filter Reminder
This message will appear when the lter reminder
time has expired (Figure 15.0e). Remove the
ProClarity/Proclear lters and lter/debris bag for
cleaning or replacement.
21. ProClarity Depth Filter Reminder
This message will appear when the lter reminder
time has expired (Figure 15.0f). The ProClarity
Depth lter must be replaced.
22. Water Refresh Reminder
This message will appear when the “Water
Refresh” timer has expired (Figure 15.0g). The
water needs to be drained and relled with fresh
water.
23. Extended Temperature Activated:
The spa is set to go up to 104°F (40°C), but it can be set to reach
106°F (41°C). To access the extended temperature you need press
and hold your nger over the temperature reading for about 5
seconds. The temperature reading will start to blink to indicate the
system is ready. Tap to raise the temperature up to 106°F (41°C).
Note: The heater icon
ON
will be blinking to indicate that the feature is
active.
It’s time to replace your CLEARRAY bulb.
Contact your authorized dealer for replace-
ment parts.
Reminder
reset
snooze
Figure 15.0d
It’s time to clean or replace your ProClarity
and ProClear filters. Contact your autho-
rized dealer if new filters are needed.
Reminder
reset
snooze
Figure 15.0e
It’s time to replace your ProClarity Depth
Filter. Contact your authorized dealer for a
new filter.
Reminder
reset
snooze
Figure 15.0f
Your spa needs to be drained and refilled
with fresh water. Refer to your owner’s
manual for draining procedure.
Reminder
reset
snooze
Figure 15.0g
To Next Page
Loading...
Need help?
General
