Jacuzzi J.Touch Use & Maintenance

38
The sanitization process cannot be in-
terrupted unless the power is discon-
nected via the main switch
It is not possible to activate the hydro-
massage during sanitization
Sanitization
W
e recommend the J-MX 07 liquid, oered by Jacuzzi and available at the Assistance
Centres/Authorised Retailers, is used to clean the tub hydraulic circuit.
QIt is possible to carry out this cleaning operation using the same water used for the
hydromassage provided that soap, oils, cosmetics,have not been used; otherwise, empty
the tub and ll it once again.
In any case, the tub water level (free of concentrates) must cover the nozzles on the
backrest.
QCheck that the outlet nozzles along the tub perimeter are open.
Where not already completed, pour the J-MX 07 liquid sanitiser into the tank.
J-MX 07
QHold down the key displayed until it becomes righter and the other keys turn o: the
pump will activate (for approximately a minute) to evenly distribute the liquid inside the
hydraulic circuit.
10 min
The function lasts approximately 10 minutes and is completely automatic; about one
minute before the end of the function, the pump activates once again to rinse the pipes.
When the key begins to ash, the function is considered complete: open the drain and
empty the tub.
It is essential to drain the water used for sanitization, the liquid can irritate the skin.
preliminary
operations
activate
the function

Jacuzzi J.Touch Specifications

General

Brand	Jacuzzi
Model	J.Touch
Category	Remote Control
Language	English