22
ROUTINE MAINTENANCE
XKeep the hot tub covered at all times when not in use. In this
way, along with keeping the water from getting dirty, you will
also avoid heat loss and evaporation.
XPeriodically clean the hydromassage and suction nozzles.
CAUTION
Never clean the hot tub with the pump running. Turn o
the main switch rst.
CAUTION
After cleaning, immediately put the grilles of the aspi-
ration nozzles back in place. These safety devices must
cover the suction intake in order to reduce the risk of
hair or other body parts getting caught. The intakes
must be cleaned with the bath empty.
Remember to ret all the parts before re-lling the hot tub.
The suction intake grilles must be checked at least once
a week.
Maintenance of cartridge lters
The lters must be periodically cleaned, according to the amount
of use the hot tub is subject to, and replaced when necessary, when
they show signs of deterioration.
The cartridges are available from Jacuzzi® authorised dealers
and Service Centres.
XCheck the skimmer at least once a week to remove any sedi-
ment such as leaves, hair, etc.
XPeriodically check the lters; with normal use of the hot tub,
it is advisable to clean the lters at least once a week (clogged l-
ters cannot keep the water clean; they also compromise proper
operation of the system).
CAUTION
Never clean the hot tub with the pump running. Turn o
the main switch rst.
XTo clean the lter, remove the cover from the skimmer and
follow the steps indicated.
XSeparate the lter folds and clean with a jet of pressurised water.
If the lter is clogged, it is advisable to use specic products for
the removal of encrustation and grease, available from author-
ized Jacuzzi® dealers and service centres.
XRet, repeating the operations in reverse order.
CAUTION
After cleaning the lter, do not re-start the hot tub until
you have re-assembled all components.
Maintenance of thermal cover
Leatherette
XUse a neutral cleaner, then rinse with clean water.
XIf necessary, use a specic product after cleaning to restore
and maintain the material’s shine.
SPECIAL MAINTENANCE
Winter inactivity
In areas where winter temperatures frequently drop below 0°C,
during periods in which the hot tub is not used, proceed as follows:
XTurn o the power supply on the main panel.
XCompletely drain the hot tub via the drain valve, which is to
be left open, and the possible gate valve installed on the auxil-
iary drain (if installed; refer to the pre-installation instructions).