Jacuzzi Lodge L User Manual

32
Low water level Add water up to the
normal level
Motor bearings worn or faulty *
The impeller rubs against the pump body *
Solid bodies in the pump *
Water leakage from shaft Pump mechanical seal worn or defective *
of the pump (rotating joint
between the pump and the motor)
The motor does not start
No power Turn on the mains switch
Main switch has tripped Turn on switch
Voltage too low Contact an electrician or the organization
that provides electricity
Circuit breaker has tripped Reset breaker
Incorrect or faulty connections *
Shaft and impeller blocked *
Motor windings burnt *
Faulty contact on motor *
start-up
The motor stops The function has ended Press the key or again
Overload Let the motor cool,
the problem should disappear.
If it persists, see *
Power supply cables not suitable Consult an electrician
The blower does not operate No power Turn on the main switch
The button or has not been fully pressed Press the button again
Main switch has tripped Turn on switch
Circuit breaker has tripped Reset breaker
Faulty motor *
* : This type of repair requires the intervention of qualied personnel.
Contact your Jacuzzi® dealer or an authorised Service Centre.
It is the responsibility of the installer/owner to ascertain compliance with specic local regulations prior to installation. Jacuz-
zi Europe S.p.A. gives no guarantee in this respect and declines all responsibility regarding the compliance of the installation
performed.

Jacuzzi Lodge L Specifications

General

Brand	Jacuzzi
Model	Lodge L
Category	Hot Tub
Language	English