www.jacuzzi.com Page 9
Whirlpool Operations (Continued)
Controlling Whirlpool Direction & Flow
CAUTION: Never run the whirlpool system with all the jets closed.
To adjust the direction of the jets:
• To change the direction of the water ow, swivel the jet nozzle to the desired angle, Figure 12.
To adjust the water ow to the jets:
• Increase the force of the ow by rotating the nozzle or jet face to the left (counterclockwise). Decrease the force of the
ow by rotating the nozzle or jet face to the right (clockwise). Reference Figure 13.
RapidHeat™
RapidHeat™ (Standard on Salon® models)
The heater turns ON automatically any time whirlpool operation is active. Heater
operation is not displayed on the control panel. There is a visible indicator light on the
heater itself that signies the heater is operating. The heater will help maintain the
temperature of the water in the bathtub. It is not intended to heat the water to a desired
temperature.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not allow
the heater to turn ON if the pump is not running and water is not owing
through the whirlpool system.
High-Limit Switch
The heater includes an exclusive High-Limit switch. This safety circuit will not false trip from hot tap water. It will only turn
OFF the heater if the thermostat fails. To reset, press the button. If the high-limit trips frequently, please contact us at
www.jacuzzi.com, or at 1-800-288-4002.
Fig. 12
Fig. 13
PUSH TO RESET
OVER HEAT
PROTECTION
HEATER ON
High Limit
Reset
Heater
On
Fig. 14
IMPORTANT NOTE:
Heater will only work when
the water temp is 77°F or
above. You should always fill
the tub with warm water.
To Next Page
Loading...
Need help?
General
