Jacuzzi SWIMSPA Power Pro J16

21
Decontaminang Procedure
Steps 9-15 below are only required when sanizer levels are unstable aer performing Swim
Spa Fill Procedures 1-6. Disregard steps 9-15 below if sanizer levels remain stable aer per-
forming steps 1-6 above (refer to the inside cover of the manual.
9. Add 71 grams of sodium dichlor for every 378 litres of water. Refer to the table below for
approximate water fill volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SWIM SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your swim spa for any reason! These
chemicals may damage components within your swim spa, burn or irritate your skin,
create a rash, and void the manufacturer warranty for your swim spa.
Water Fill Volume by Model
Model Average Fill Volume* Sodium Dichlor
J16 2010 USG (7638 Litres) 1425 grams
J19 2378 USG (9038 Litres) 1687 grams
* Use average fill volume for chemical maintenance
10. Leave swim spa cover open during this step to allow excessive chemical vapours to exit
the swim spa, protecng pillows and plasc knobs from chemical aack. If the swim spa
is indoors, open doors and windows for proper venlaon. Turn on all swim spa jet
pumps for one hour, open all air controls, and place all massage selector knob(s) in their
center “combo” posion.
Note: You will need to acvate the jet pumps every 20 minutes since these funcons
have an automac 20 minute me-out that turns them off.
WARNING: RISK OF PERSONAL INJURY!
 To decrease the risk of injury, drowning or entrapment, never leave your swim spa un-
aended for any reason while the cover is open and accessible, especially to small chil-
dren and animals.
 Precauons should be taken to minimize your exposure to chemical vapours (that could
cause lung, brain, or skin damage).