33
M8 Mode
M8 will automacally determine when to turn the pumps on depending on the condions
and the ambient temperature. If the sensors do not detect a decrease in water temperature
from the last me it was checked, M8 will gradually increase the intervals all the way to 2
hours if the condions are very stable.
If a user removes the spa cover for example and the spa temperature starts dropping signifi-
cantly, M8 will immediately reduce the checking intervals down to 30 minutes. M8 resets the
checking intervals to 30 minutes whenever the user interacts with the system (acvates
equipment, changes heang modes, changes the set temperature etc). Once the user stops
interacng with the system, M8 will resume trying to find the best possible me and frequen-
cy at which the temperature needs to be checked.
When M8 is disabled, the system returns to its normal 30 minute intervals to check the tem-
perature. When M8 is re-enabled, it resumes it search for an opmized frequency at which
the temperature should be checked.
Incorporang M8 helps to minimize your energy consumpon, supports pump longevity and
helps reduce the frequency of noise associated to the pumps running.
To Next Page
Loading...
