Jacuzzi SWIMSPA Power Pro J19

23
15. Establish a sanizer reading no less than 1.0 ppm free chlorine or 2.0 ppm bromine, then
allow the swim spa to set undisturbed for 8 hours. Retest water aer 8 hours to deter-
mine if sanizer levels are stable. If sanizer levels are stable, your swim spa is ready for
use. To ensure healthy water condions, always maintain a constant sanizer reading
within the levels recommended on the inside cover of this manual. If sanizer levels are
not stable at this me, it will be necessary to repeat this procedure in its enrety unl
stable sanizer readings are achieved.
IMPORTANT: If the CLEARRAY® water purificaon system is removed from the swim spa or is
not operang effecvely follow the “without CLEARAY®” chemistry parameters as defined by
the Associaon of Pool and Spa Professionals.
16. Aer adequate sanizer levels are achieved, close all swim spa controls to maximize heat
retenon when the swim spa is not in use.