19
Decontaminating Procedure
Steps 9-15 below are only required when sanitizer levels are unstable after performing
Swim Spa Fill Procedures 1-6. Disregard steps 9-15 below if sanitizer levels remain stable
after performing steps 1-6 above (refer to the inside cover of the manual.
9. Add 71 grams of sodium dichlor for every 378 litres of water. Refer to the table be-
low for approximate water ll volume by model.
Water Fill Volume by Model
Model Average Fill Volume* Sodium Dichlor
JC 16 2010 USG (7638 Litres) 1425 grams
JC 19 2378 USG (9038 Litres) 1687 grams
* Use average ll volume for chemical maintenance
10. Leave swim spa cover open during this step to allow excessive chemical vapours
to exit the swim spa, protecting pillows and plastic knobs from chemical attack. If
the swim spa is indoors, open doors and windows for proper ventilation. Turn on all
swim spa jet pumps for one hour, open all air controls, and place all massage selec-
tor knob(s) in their center “combo” position.
Note: You will need to activate the jet pumps every 20 minutes since these functions
have an automatic 20 minute time-out that turns them o.
CAUTION: RISK OF PERSONAL INJURY OR SWIM SPA DAMAGE!
Never add chlorine tablets (trichlor) or acid to your swim spa for any reason! These
chemicals may damage components within your swim spa, burn or irritate your
skin, create a rash, and void the manufacturer warranty for your swim spa.
WARNING: RISK OF PERSONAL INJURY!
• To decrease the risk of injury, drowning or entrapment, never leave your swim spa
unattended for any reason while the cover is open and accessible, especially to
small children and animals.
• Precautions should be taken to minimize your exposure to chemical vapours (that
could cause lung, brain, or skin damage).
To Next Page
Loading...
Need help?
General