24
10.0 Swim Spa Operation
10.1 Main Screen
Important information about the swim spa operation can be seen on the “Main Screen”. Most
features including Set Temperature adjustment, can be accessed from this screen. The actual
water temperature can be seen and the Set Temperature can be adjusted. Time of Day, Ozone
and Filter status is available along with other messages and alerts. The selected Temperature
Range is indicated in the upper left corner of the display. The Spa Equipment Control Icon will
spin if any pump is running. A Lock Icon is visible if the panel or settings are locked.
Note: After 30 minutes* the display will automatically go into sleep mode, which turns the
display o. This is normal operation. Touch anywhere on the screen to wake the panel up.
• H = High Temperature Range L = Low Temperature Range
• R = Ready Mode RR = Ready / Rest Mode IR = Rest Mode
• F1 = Filter Cycle 1 running F2 = Filter Cycle 2 running F+ = Both running
• O3 = Ozone is running. If you do not see the icon that means the ozone is o.
• C = Clean-up cycle is running. Note: Not all systems that can run a Cleanup Cycle dis-
play this icon.
• Wi-Fi icon just indicates that the Wi-Fi link is connected
• Invert (or ip) Screen
Clean-up Cycle
Ozone Running
Filter Cycle 1 Running
High Temperature Range
Lights
Music
Set Temperature
Settings
Heat
Time
Wi-Fi Signal Indicator
Lock
Invert Screen
Jets
Temperature
Scale (F/C)
To Next Page
Loading...
Need help?
General