EasyManuals Logo
Home>Jacuzzi>Hot Tub>SWIMSPA Series

Jacuzzi SWIMSPA Series User Manual

Jacuzzi SWIMSPA Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
41
9. To completely ush the old water from the plumbing lines: allow fresh water to ll
into the foot-well area while the old water continues to be pumped out. Always
keep at least 10cm (4 in.) of water in the foot-well so that pump 1 remains primed.
10. When the water from the drain hose turns clear (indicating fresh ll water), ush is
complete.
11. Turn OFF the ltration pump.
12. Close the drain-hose bib on the swim spa plumbing line and
continue lling swim spa with fresh water.
13. Place cover on swim spa (to avoid splash-out).
14. Open ltration pump return gate valve.
15. Press any button on the topside control panel (other than the pump 1 button) to
take the system out of STANDBY/DRAIN ASSIST mode. Filtration pump and the
heater will activate to circulate and heat the water while lling continues. This also
reduces the possibility of an airlock occurring.
16. Continue adding fresh ll water until level is approximately 19mm (3/4 in.) from the
top of the skimmer opening.
12.3 Cleaning the Swim Spa Interior
To preserve the sheen of your swim spas surface, it is crucial that you avoid using abrasive
cleaners or cleaners which have adverse chemical eect on the surface. If you are not cer-
tain as to the suitability of a particular cleanser, consult your authorized Jacuzzi dealer. We
recommend using Jacuzzi’s Spa All Purpose Cleaner to clean the swim spas interior surface.
Use extreme care to assure that no soap residue is left on the surface. This could cause se-
vere sudsing when the swim spa is relled. Jacuzzi chemicals are for use in the U.S. only.
12.4 Pillow Care
Clean the headrests in your swim spa as needed by wiping them with a cloth with soapy
water. It is not necessary to remove the headrests for cleaning. To remove headrests for
long term storage or replacement, grasp both ends of each headrest and gently pull inward
towards the center of the swim spa. To reinstall, over mounting strip and press down until
headrest mounting bracket emits a click sound. Then adjust the headrest height by simply
moving up or down as desired.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi SWIMSPA Series and is the answer not in the manual?

Jacuzzi SWIMSPA Series Specifications

General IconGeneral
BrandJacuzzi
ModelSWIMSPA Series
CategoryHot Tub
LanguageEnglish

Related product manuals