EasyManuals Logo

Jacuzzi SWIMSPA Series User Manual

Jacuzzi SWIMSPA Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
10. Cool Warning: Swim spa water is more than 20
o
F / 11
o
C cooler than the temperature
set point , the circulation pump and heater will automatically activate to provide
freeze protection. The swim spa will stay in this mode until the water temperature
reaches 14
o
F / 8
o
C below the set temperature. No corrective action is necessary.
Note: The heater icon will be blinking and the error icon will be displayed under the
temperature.
11. Freeze protection: A potential freeze condition has been detected. No action is re-
quired. Jet pump(s) operate until the swim spa is out of danger. No corrective action is
necessary. If condition persists, contact your authorized dealer or service organization.
12. Overheat protection: DO NOT ENTER THE WATER! Water temperature is above
acceptable limits. Heater is deactivated. Remove swim spa cover to speed cooling. If
condition persists, contact your authorized dealer or service organization.
Note:
As a safety measure, the red lights of the swim spa will ash on and o as an
indication that the swim spa is in an overheat condition.
The heater icon will be blinking and the error icon will be displayed under the
temperature.
13. Controller Overheat Protection: Controller temperature has exceeded acceptable
limits. If condition persists, provide shade for equipment side of swim spa. Contact
your authorized dealer or service organization.
Note: The heater icon will be blinking and the error icon will be displayed under the
temperature.
14. Panel Com Error: The topside controller is having trouble communicating to your
swim spa. Contact your authorized dealer or service organization.
15. CLEARRAY Replacement Reminder: This message will appear when the CLEARRAY
bulb reminder time has expired. The CLEARRAY bulb must be replaced.
16. Clean Filter Reminder: This message will appear when the lter reminder time has
expired. Remove the lters for cleaning or replacement.
17. Water Refresh Reminder: This message will appear when the Water Refresh timer
has expired. The water needs to be drained and relled with fresh water.
WARNING: RISK OF HYPERTHERMIA (OVERHEATING) CAUSING
SEVERE INJURY, BURNS OR WELTS.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi SWIMSPA Series and is the answer not in the manual?

Jacuzzi SWIMSPA Series Specifications

General IconGeneral
BrandJacuzzi
ModelSWIMSPA Series
CategoryHot Tub
LanguageEnglish

Related product manuals