7
For connection to the supply network, we recommend installing an isolating multi-pole
switch, which will ensure complete disconnection in the event of a category III over-voltage;
these devices must be placed in an area that complies with the safety regulations.
CAUTION! Before carrying out any maintenance operations, disconnect the appli-
ance from the power supply line.
CAUTION: (IEC 60335-1) The pressure of the hydraulic system that supplies the
equipment must not exceed 600 kPa (6 bar) and, in case water is supplied through
solenoid valve(s) (eg. Balance tank) the pressure must have a minimum value of 35
kPa (0.35 bar)
This equipment may be used by children above the age of 8 or individuals with reduced
mobility, sensory and/or cognitive abilities only if supervised and only if they have the
knowledge necessary to use the equipment safely, as well as to understand the dangers
arising from improper use.
Children must be supervised to make sure they do not play with the equipment and donot
carry out operations to be performed by adults and/or specialized personnel (maintenance,
cleaning operations, etc.).
Do not use water with temperatures exceeding 40
o
C.
Tolerance to hot water varies from person to person. Pregnant women and small children
must not use the swim spa without rst consulting a doctor and, in any case, the water tem-
perature must be less than 38
o
C.
Be very careful when using the swim spa alone. Prolonged immersion in warm water may
cause nausea, dizziness and fainting. If you intend to use the swim spa for more than 10-15
minutes, a lower water temperature must be set. This also applies to children.
To Next Page
Loading...
Need help?
General