Need help?Do you have a question about the Jadis JA30 and is the answer not in the manual?
General| Output Power | 30 Watts per channel |
|---|---|
| Frequency Response | 20 Hz to 20 kHz |
| Input Impedance | 100 kOhms |
| Signal-to-Noise Ratio | 90 dB |
| Type | Tube Amplifier |
| Impedance | 4, 8 Ohms |
| Tubes Used | ECC83, ECC82 |
| Bandwidth | 20Hz - 20kHz |
| Output Impedance | 4, 8 Ohms |
Details of the front panel controls, including power switches and LEDs.
Details of the rear panel connectors for input and output signals.
Diagram showing the correct positions for vacuum tubes on the amplifier chassis.
Step-by-step guide for installing vacuum tubes, including important precautions.
To Next Page
