Installation instructions
Read this carefully.
Optimum listening quality is obtained when the following
recommendations have been observed step by step.
1 - Each Jadis amplifier unit is packed with its own tested tubes.
Place the tubes: be careful not to mix up the tubes and place them
immediately on to their corresponding place as indicated in the « Tube
position » .
2 - Place your Jadis amplifier on a flat, solid surface. Avoid placing
the units directly on a carpet or on inflammable material. Avoid placing
objects on top of the amplifier to ensure adequate ventilation.
3 - Because your Jadis is a tube amplifier, provide an open space to
allow a correct evacuation of heat. Do not try to cool your Jadis
amplifier with a fan or expose it to air currents: sudden cooling can
create microcracks on the tubes. Do not move your amplifier when the
tubes are hot.
4 - Always turn on your preamplifier before turning on the amplifier.
Reverse the procedure when turning off your amplifier. To ensure long
term reliability the ON/OFF power switch must be operated with a quick firm
movement. Always use the ON/OFF Switch. Never unplug the mains cord
to turn off the unit. If it is necessary to change a cable or to modify a
connection, make sure the amplifier and the preamplifier have been
switched off for a least three minutes before proceeding.
To Next Page
Loading...
