Installation instructions
Read this carefully.
Optimum listening quality is obtained when the following
recommendations have been observed step by step.
1 - Each Orchestra is packed with its own tested tubes. Place the
tubes: be careful do not mix up the tubes and place them immediately on
to their corresponding place as indicated in the « Tube position » page 9.
2 - Place your Jadis amplifier on a flat, solid surface. Avoid placing
the units directly on a carpet or on inflammable material. No placing
objects on top of the amplifier to ensure adequate ventilation.
3 - Because your Jadis is a tube amplifier, provide an open space to
allow a correct evacuation of heat. Do not try to cool your Jadis
amplifier with a fan or expose it to air currents: sudden cooling can
create microcracks on the tubes. Do not move your amplifier when the
tubes are hot.
4 - Always turn on your source before turning on the Orchestra.
To ensure long term reliability the ON/OFF power switch must be
operated with a quick firm movement. Always use the ON/OFF Switch.
Never unplug the mains cord to turn off the unit. If it is necessary to change
a cable or to modify a connection, make sure the orchestra have been
switched off for at least three minutes before proceeding.
To Next Page
Loading...
Need help?
General
