2-3
Mounting the Black Cat II Radar Recorder
Once a site has been selected, the Black Cat II Radar Recorder can be
easily mounted using the installation kit.
Step #1 - Thread the SnapLock clamp bands through the openings on
the pole bracket.
Step #2 - For the most accurate results, the bracket should be installed
so the Black Cat II Radar Recorder is facing traffic on a 45 degree angle.
IMPORTANT: The
area of the Black Cat
II Radar Recorder
that you are aiming
toward the road on
a 45 degree angle is
the crosshairs on the
front of the Radar
head, as shown in the
picture here.
Once you have determined the 45 degree angle for the bracket, wrap the
bands around the pole and place the bracket.
Chapter 2 — Site Installation
To Next Page
