Black Cat II Radar Recorder User’s Manual
3-2
Connecting the
Black Cat II Radar to Your Computer – USB Port
Once you have the Black Cat II Radar Recorder installed, it needs to be
programmed to record the data you want. To do this you'll need to connect
a USB cable from your computer to the Black Cat II's mini USB Port.
Note that BEFORE you connect your computer to the Black Cat II for the
first time, run the USB Driver Installation Program, which can be found on
the STARnext software flash drive.
STEP 1 – Open the case of the
Black Cat II Radar Recorder.
STEP 2 – Press the Wake button to
‘wake up’ the Black Cat II. The Run/
Vehicle light will be on when the
unit is awake. Note that you must
always ‘wake up’ the Black Cat II
before you connect when using the
USB cable.
STEP 3 – Once the Black Cat II is
awake, plug the USB cable into a
standard USB port on your com-
puter.
Connecting the
Black Cat II Radar to Your Computer
There are three ways to connect the Black Cat II Radar Recorder to your
computer:
• Direct hardwire USB connection.
• Local wireless Bluetooth connection.
• Remote GSM modem connection (optional).
To Next Page
