Black Cat II Radar Recorder User’s Manual
3-4
Once the Black Cat Radar Recorder Setup screen appears, select the COM
Port from the dropdown box and click the Connect button.
STARnext will at-
tempt to connect to
the Black Cat II Radar
Recorder and, if suc-
cessful, show the cur-
rent status of the unit.
Once connected, the
middle of the screen
will show the Counter
Info, which includes:
• Battery voltage – the current voltage of the battery. A fully charged
battery should be around 13V or higher. The Radar will not be able to
start if the voltage is below 12V.
• Primary firmware & Detector firmware number – updates for these
are posted periodically at www.jamartech.com.
• Count Type – defaulted to Per Vehicle
• Counter Status – this will be either Not Counting if no count is in
progress or Counting... if a count is in progress.
• Date/Time – this is the date & time current programmed in the unit.
You will be shown a warning that the date and time are not correct if they
are not within a minute of the computer’s date and time. This will be
automatically corrected the next time you upload settings to the unit.
To Next Page
