RAC Plus User’s Manual
4-12
Enter. The event code, distance, speed and time (elapsed or real) are stored
in memory.
There is a short delay (1/2 second) when you press Enter before you can key
in another event code. However, the code you entered is written to memory
at the instant you press Enter.
Should you key in an incorrect code number, you can overwrite that number
by simply keying in the correct number. This must be done prior to press-
ing the Enter key. Once you hit the Enter key, the code that was in D-2 is
stored in memory.
Step 8
When the inventory route is completed,
press the CH key. Key in an ending ref-
erence code (such as 9999) to mark the
end of the survey, then press Enter.
Note that you can store up to 3500
events in the RAC Plus II's memory.
Step 9
To exit the memory store function, the RAC must be in Count Hold. Press
the Menu key, then press Enter. You are now back in normal mode.
Note: To begin another survey, go back to Step 1.
Fig. 4.23 —
Enter Ending Reference Code
To Next Page
Loading...
