Page 14
Page 15
8. Remove the top two screws on Pentair control panel, swing panel down to
allow access to wiring behind it, see Figure 9(a).
a
Figure 9. Remove Pentair
®
Control Panel Screws
9. Disconnect power connection from the transformer.
10. Unplug Valve actuator’s, mark them intake and return.
11. Disconnect the Ethernet cable, see Figure 10(a).
12. Unplug the auxiliary relays, see Figure 10(b).
a
b
Figure 10. Unplug Auxilary Relays
13. Unplug RS-232, including saltboard if one exists.
14. Unplug spa controller (if installed).
Installation & Operation Manual
To Next Page
Loading...