Installationsanvisning Janfire Flex - a
IA Brännare Flex-a R2 SV
Janfire 2009
4(19
)
1 Safety Instructions
1.1 General Information
The security regulations base on a risk analysis that has been implemented according to relevant
EU directives in order to meet the European standards for CE labelling.
At each installation, the installation checklist completed and archived. This is very important to the
customer's warranty shall apply.
Read the safety instructions carefully before installation. Always follow the safety instructions
during installation and during maintenance. Follow the safety instructions on the warning signs!
Installation, operation, service and any other work should be carried out by qualified personnel and
in accordance to local standards and regulations.
When unpacking, the burner should be checked for any damage. If any parts are damaged contact
the installing contractor.
The local chimney sweep must be informed, an examination of the existing chimney must be
performed and a local building application may be necessary depending on local code
requirements.
Before using the system, it must be controlled and fine-tuned. Adjustments and readings are made
during start up. These observations should be written into the installation protocol. This is very
important in order to customer guarantee will apply.
NOTE: When restarting the system turn the burner fan on for 10 minutes to cool down any
remaining cinders.
NOTE: Always follow these instructions for installation, operation and service.
NOTE: For personal and operational safety: Use only spare parts, which have been manufactured
or approved by Janfire AB.
To Next Page
Loading...
