Janome 900 - Connecting Power and Foot Control

5
1
2
3
4
5
6
Connecting the Machine to the Power Supply
Before connecting the power cord, make sure the voltage and
frequency shown on the machine conform to your electrical
power.
1. Turn off the power switch.
2. Insert the machine plug into the machine socket.
3. Insert the power supply plug into the outlet .
4. Turn on the power switch to turn on the power and sewing
light.
q Power supply plug
w Power switch
e Outlet
r Machine socket
t Machine plug
y Foot control
Caution:
Do not place anything on the foot control, otherwise the
machine will start advertently.
Foot control
Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the machine
runs.