Janome dc2015 - LCD Display; Selecting Stitch Patterns

18
LCD Display
The LCD display shows the following information when
the machine is turned on.
q Identification letter for recommended foot
w Stitch pattern number
e Cursors
r Stitch width
t Stitch length
q
w
e
r
t
z
x
c
Selecting Stitch Patterns
z Press the cursor buttons to move the cursor
under the stitch pattern number.
The cursors appear under both digits when turning
the power on.
x Press the value set buttons to change the stitch
pattern number until the pattern number of the
desired stitch is indicated.
The number will increase or decrease by 1 each time
you press the value set button.
c Press the button to move the cursor under the tens
digit of the stitch pattern number.
The number will increase or decrease by 10 each
time you press the value set button.
Stitch Patterns