6
To Snap On and Snap Off the Presser Foot
To snap off
Turn the handwheel toward you to raise the
needle to its highest position. Raise the presser
foot.
Press the red button on the back of the foot holder.
The presser foot will drop off.
q
Red button
To snap on
When attaching the presser foot, the pressure
dial should always be at position “3”.
Place the presser foot so the pin on the foot lies
just under the groove of the foot holder.
Lower the foot holder to lock the foot in place.
CAUTION:
Turn the power switch off before replacing
the presser foot.
To Detach and Attach the Foot Holder
To Detach
Remove the thumbscrew by turning the screw
counter-clockwise with the screwdriver.
q
Presser bar
w
Foot holder
e
Thumbscrew
To Attach
Align the hole in the foot holder with the threaded
hole in the presser bar and fit the foot holder
screw into the hole. Tighten the screw by turning
it clockwise.
q
q
w
e
w
e
q
To Next Page
Loading...
