Janome HD2200 - Automatic Buttonhole

24
n m ,
.
⁄0
⁄1
⁄2
n Insert the fabric under the foot.
Turn the handwheel one complete turn by
your hand.
m Remove the fabric to the left to draw both
threads to the left.
, Insert the garment under the foot, and lower
the needle at the starting point.
Then lower the automatic buttonhole foot.
. Sew slowly and stop the machine at the
starting point when a buttonhole is completed.
* The machine sews front bartack and left row
first, then the back bartack and right row.
⁄0 Cut the both needle and bobbin threads
leaving about 10 cm (4˝) thread ends.
Draw the needle thread to wrong side of
fabric by pulling the bobbin thread.
Then, knot the threads.
⁄1 Cut the both needle and bobbin threads
leaving about 10 cm (4˝) thread ends.
Draw the needle thread to wrong side of
fabric by pulling the bobbin thread.
Then, knot the threads.
⁄2 To repeat buttonhole sewing.
After a buttonhole is sewn, move the indicator
to pattern “13” [ ] by turning the pattern
selector dial in the direction of arrow 1, then
return the indicator back to “BH” by turning
the dial in the direction of arrow 2 to reset for
sewing the next buttonhole.
⁄3 When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
⁄3
1
1
2
2