Janome MB-4S - SECTION 2. BASIC OPERATION; Basic Operation with Sub Control Panel; Machine Operating Buttons; Function Buttons

22
Setting the Fabric in the Embroidery Hoop
z
Attach stabilizer to the wrong side of the fabric.
Mark the centerlines for pattern placement on the
right side of the fabric.
q
Fabric
w
Centerlines
e
Stabilizer
CAUTION:
Thick and hard materials such as multi-layer canvas
may cause needle to warp or break.
x
Place the inner hoop with the template on the
fabric. Make sure that the arrow marks on the
hoop and template are facing away from you.
Align the centerlines on the fabric and
template.
r
Inner hoop
t
Template
y
Arrow mark
c
Loosen the hoop tightening screw on the outer
hoop.
u
Outer hoop
i
Hoop tightening screw
v
Hold the inner hoop and fabric together and push
them into the outer hoop. Make sure to keep the
centerlines aligned.
Do not push the setting plates, push the 4 corners
of the inner hoop.
o
Setting plate
b
Tighten the hoop tightening screw slightly. Pull the
edge of the fabric to stretch it drum-tight.
NOTE:
Make sure the bottom of the inner hoop is level with
the outer hoop.
n
Tighten the hoop tightening screw securely.
m
Remove the template.
q
w
e
r
t
y
u
i
o
i
i
t
z
x
c
v
b
n
m