Error Messages
Error Description
Communication error with the
RCS unit.
Initializing error.
Needle bar switching error.
Needle bar stop position error.
Driving motor stops due to an
overload.
Needle thread broke or ran
out.
Needle bar setting error.
Auto thread cutting error.
Opening tension disks while
stitching.
Upper shaft stop position
error.
Remedy
Turn the power switch off and turn it on again.
Turn the power switch off and turn it on again.
Turn the power switch off and turn it on again.
Press the ENTER button to reset the machine.
After 15 seconds, the LCD screen will show the
Ready to Sew mode display. Remove jamming
threads or other cause of overloading.
Press the MODE key to return to the Ready to
Sew mode and re-thread the needle.
Press the MODE button to return to the Ready
to Sew mode then set the needle bar number.
Turn the power switch off and turn it on again.
Pull the tension release lever to close the tension
disks. The LCD screen will show the Ready to
Sew mode display.
Turn the power switch off and turn it on again.
Error Message
Audible Signals
pip Normal operation
pip-pip-pip-pip Invalid operation or malfunction
pip-pip Thread color change
pip-peep pip-peep Embroidery completed
peep Malfunction
Audible signal
The buzzer sounds when:
To Next Page
Loading...
