EasyManua.ls Logo

Janome Memory Craft 300E - Needle Threader

Janome Memory Craft 300E
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Needle Threader
1 Lower the presser foot. Depress the needle
threader knob as far as it will go. The hook
comes out through the needle eye from behind.
1 Needle threader knob
2 Hook
2 Draw the thread down around the threader guide
and under the hook.
3 Threader guide
3 Release the threader knob slowly while holding
the thread end with your hand. A loop of the
thread is pulled up through the needle eye.
4 Remove the loop from the threader and pull out the
thread end from the needle eye.
NOTE:
The needle threader works well with the threads #50-
100 and needles #11-16, the blue tipped needle as well.
1
2
3
4
1
2
3
2

Related product manuals