15
Threading the Machine
Raise the Presser Foot Lifter. Press the Up/Down
Needle Button twice to raise the needle to its highest
position.
Turn the Power Switch OFF.
1 Hold the upper thread with both hands as shown
and place it down into the Slit.
2 Draw the thread around the Thread Guide following
the dashed line as shown in the diagram.
3 Then draw the thread down along the right channel
and around the bottom of the Thread Guide Plate.
1 Right Channel
4 Firmly draw the thread up along the left channel to
the Take-up Lever and down into its eye from the
right to the left.
2 Left Channel
5 Then pull the thread down along the left channel
and through the Lower Thread Guide.
6 Slide the thread behind the Needle Bar Thread
Guide on the left.
7 Thread the needle from front to back by hand or
using the Built-in Needle Threader.
12
3
4
5
6
7
4
2
1
6
7
5
3
1
2
To Next Page
Loading...
