Janome Sew Mini - Page 15

12
Inserting the bobbin
Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
q Thread
w Bobbin holder
Guide the thread into the notch on the front of
the bobbin holder.
e Notch on the front
Draw the thread to the left, sliding it between
the tension spring blades.
r Spring blades
Continue to draw the thread lightly until the
thread slips into the notch on the side.
t Notch on the side
Pull out about 10 cm (4") of thread to the rear.
Reattach the hook cover plate.
y Thread
u Hook cover
q
w
e
r
t
u
y