Need help?Do you have a question about the Janome Skyline S5 and is the answer not in the manual?
General| Stitch Patterns | 170 |
|---|---|
| Maximum Stitch Width | 9mm |
| Maximum Stitch Length | 5mm |
| Needle Positions | 91 |
| Bobbin System | Top loading full rotary hook bobbin |
| LCD Screen | Yes |
| Start/Stop Button | Yes |
| Speed Control Slider | Yes |
| Needle Up/Down Button | Yes |
| Thread Cutter | Automatic |
| Type | Computerized |
| Speed Control | Yes |
| Memory Function | Yes |
| Sewing Speed | 820 stitches per minute |
| Lighting | LED |
| Needle Threader | Built-in |
| Work Space | 210mm |
| Presser Feet | 7 |
| Warranty | 25 years limited |
| Buttonholes | 10 (1-step) |
Instructions for removing and attaching the face cover.
Instructions for removing and attaching the belt cover.
Instructions for removing and attaching the top cover.
Procedures for removing and attaching the machine base.
Procedures for removing and attaching the base cover.
Procedures for removing and attaching the bed cover.
Procedures for removing and attaching the free arm cover.
Procedures for removing and attaching the front cover.
Procedures for removing and attaching the rear cover.
Procedures for removing and attaching Printed Circuit Board A.
Procedures for removing and attaching Printed Circuit Board F.
Procedures for removing and attaching the switching power supply unit.
Procedures for removing and attaching the DC motor.
Procedures for removing and attaching the thread tension unit.
Adjusting the feed dog's highest position relative to the needle plate.
Adjusting the needle's lateral and vertical position in the needle plate hole.
Setting the clearance between the presser foot and needle plate.
Adjusting the gap between the needle and rotary hook.
Synchronizing the hook's rotation with the needle's movement.
Adjusting the distance for the needle bar's ascent.
Adjusting the switch that controls the presser foot lifter.
Reducing play in drive gears for smooth operation.
Positioning the shield plate for correct zigzag stitch swing.
Setting the thread tension for proper stitch formation.
Adjusting or replacing the needle threader plate hook.
Calibrating the buttonhole lever for accurate stitching.
Setting the distance for the thread cutter mechanism.
Adjusting the solenoid for thread tension release.
Balancing the feed for stretch stitches.
Verifying and adjusting the needle plate sensor switch.
Steps to prepare and start the self-diagnostic test.
Tests for LCD, buttons, sensors, motors, and thread tension.
Checks foot control, thread cutter, feed dog, and needle plate.
Displays program version and calibrates touch panel keys.
To Next Page