6
Changing external parts
Fig. 1
Rear cover
Setscrew A
Setscrew B
Fig. 2
Setscrews C
Rear cover
To remove:
1. Lower the presser foot.
2. Remove the belt cover, top cover and base cover (see
pages 1, 2 and 3).
3. Loosen the setscrews A and B (see fig. 1).
Remove the setscrews C (see fig. 2)
4. Push the rear cover from the holes D and E with a
screwdriver to remove the hook of rear cover.
5. Remove the rear cover.
To attach:
1. Follow the above procedure in reverse.
Rear cover
Fig. 3
Hole D
Fig. 4
Hole E
To Next Page
Loading...
