5
Changing external parts
Setscrew A Setscrew A
Front cover
To remove:
1. Remove the top cover, belt cover, base cover, machine
base and free arm cover (see pages 1-4).
2. Loosen the setscrews A (inside of the machine base).
Setscrew B
Setscrew C
Setscrew D
3. Remove the setscrew B.
4. Loosen the setscrew C (inside of the face cover).
5. Loosen the setscrew D (inside of the belt cover).
6. Unlock the hooks from the front cover.
Remove the connectors from the circuit board A.
Remove the front cover.
To attach:
1. Follow the above procedure in reverse.
Refer to page 7 for locating connector posts.
Hooks
To Next Page
Loading...
