10
200 g pressure
5 mm
Setscrews
Setscrews
DC motor
To remove:
1. Remove the belt cover, the top cover and the front
cover (see pages 1, 2 and 5).
2. Disconnect the DC motor connector from the printed
circuit board A (see page 7).
3. Remove the motor belt.
4. Remove the setscrews (2 pcs), and the driving motor.
Replacing electronic components
To attach:
1. Attach the driving motor. Tighten the setscrews
temporarily.
2. Adjust the motor belt deflection to about 5 mm by
pressing the middle of the motor belt with your finger
with approximately 200 grams of pressure.
3. Tighten the setscrews securely.
4. Plug the DC motor connector to the printed circuit
board A (see page 7).
5. Attach the front cover, the top cover and the belt cover.
Motor belt
To Next Page
Loading...
