1
Changing external parts
Face cover
To remove:
1. Remove the setscrews A.
Remove the face cover.
To attach:
1. Follow the above procedure in reverse.
Setscrew A
Face cover
Belt cover
To remove:
1. Remove the setscrews A and B.
2. Loosen the setscrew C.
3. Remove the belt cover from the main body.
Be careful not to pull the relay connector.
4. Disconnect the relay connector between the printed
circuit board A and the thread cutter switch socket.
5. Remove the belt cover.
To attach:
1. Follow the above procedure in reverse.
Setscrew A
Setscrew B
Setscrew C
Setscrew C
Belt cover
Relay connector
Cap
To Next Page
Loading...
