INSTALLATION INSTRUCTIONS
STEP 5.
“Fitting the logic controller”
Carefully uncoil the cables from the drive unit and locate them such that
they are protected from any mechanical damage
Locate a suitable position for the fitment of the logic controller ensuring
adequate free cable length
The logic controller shall be installed on the same side of the opening as
the drive unit
The logic controller shall be installed at a minimum of five (5) feet from the
ground and a maximum of three (3) feet from the edge of the opening and
with a clear view of the surrounding area
The front cover is secured with four captive screws
If required—carefully unplug the main control panel loom plug from the ter-
minal
NOTE OF CAUTION !!
Connect the mains power in strict accordance with all local and NEC
wiring codes
To Next Page
Loading...