INSTALLATION INSTRUCTIONS
The Pantheon logic controller is
designed to operate the drive unit
when fitted to either LH (left hand)
side or RH (right hand) side
installations – as viewed from inside
looking outward.
To correctly hand the logic controller
to match the drive unit installation –
move the DIRECTION jumper to the
required position.
LH OPERATION
RH OPERATION
NOTE OF CAUTION !!
ALWAYS SWITCH MAINS POWER OFF WHEN HANDING THE OPERATOR
STEP 6.
“Handing the operator to suit
the installation — LH or RH
side drive“
This handing feature does not
apply to Pantheon “mini “ -
operators
All Pantheon “mini “operators will have the
direction jumper removed and fitted to the
JSS (Mini) position – as standard factory
issue
To Next Page
Loading...