Jarvis VC - Notice to Operators, Maintenance and Cleanup Personnel

notice to operators, maintenance
and cleanup personnel
Model VC
page 3 of 12
JARVIS
6222009::.
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-- 4926
UNITED STATES OF AMERICA E--MAIL. jarvis.products.corp@snet.net
TEL. 860--347--7271 FAX. 860--347--6978 WWW.jarvisproducts.com
®
1. Disconnect the air supply in accordance with OSHA’s lockout/tagout procedures (29 CFR 1910.147)
before changing the blade.
2. Disconnect the air supply in accordance with OSHA’s lockout/tagout procedures (29 CFR 1910.147)
before performing any repairs or maintenance.
3. Disconnect the air supply -- or have the air supply disconnected -- in accordance with OSHA’s lockout/
tagout procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect the air hose when the tool is not in use.
5. Never put fingers, hands or other parts of the body on the cutting edge of the blade or in the cutting path
of the tool.
6. Always wear a steel mesh glove on the hand that is not
operating the tool. Always wear steel mesh
gloves when handling the blade.
7. Test the tool prior to use or daily. Pull the trigger and the tool should
start; release the trigger and the
tool should stop. If the tool malfunctions, remove it from service and report or repair it immediately.
8. Never depress the trigger unless you want to use the tool.
9. Never make modifications or alterations to the tool. Report or replace any missing or illegible l abels.
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
Keep hands clear