Jasco ZigBee ZB4001 - ZigBee Network Integration and Management; ZigBee Network Pairing; Device Reset Procedures; LED Indicator Functions

ZigBeeNetworkPairing
JointheswitchtotheZigBeeNetwork
1. FromyourZigBeeController’sinterface,choosetoaddlightingdeviceandenter
Locating/Pairingmodeasinstructedbythecontroller.
2. AfterapplyingpowertotheIn‐Wallswitch,yourIn‐WallSwitchwillbeginautoscanmodeasit
searchesforacontrollertopairwith

Auto‐Scan:LEDStatusIndicatorBlinks3xevery10secondsasthedevicescansfora
compatiblenetworkcontrollertopairwithuntilTimeout.
Timeout:Auto‐ScanmodewilleventuallytimeoutaftertheLEDStatuslightstops
blinking.IfdeviceTimeoutoccursbeforetheswitchhasjoinedtheZigBeenetwork,

pressanybuttonontheswitchtoresumescanning.
3. AftertheswitchislocatedandpairedtotheZigBeenetwork,theLEDStatusIndicatorwillstop
blinkingandtheswitchwillappearinyourcontroller’smenu.SetuptheswitchasanOn/Off
controlandtitletheswitchina 
waythatwillbeeasytoidentify.
ThemoduleisnowpairedtotheZigBee networkandcanbecontrolledremotely.
ResetDevice(RemovefromZigBeeNetwork)
FromtheZigBeeController
Fromyourcontrollerorhubinterface,choosetoremoveordeletethelightingdeviceasinstructed.The
devicewillberemovedfromtheZigBeenetworkfollowingindicationfromyourcontroller.All
configurationparameterswillberesetafterthedeviceisremovedfromthenetwork.
Manual
Tomanually
resetandremovethedevicefromtheZigBeenetwork,TapTopofRocker(ONSwitch)10x
quickly(shortpresses)
LEDParameters
Toassistwithlocatingtheswitchinadarkroom,theLEDglowsbluewhenthelightswitchisturnedOFF.
ToturnLEDoff:
 Taptoprocker(ONSwitch)3xquicklyandthentapbottomrocker(OFFSwitch)1x
TorestoreLED:
 UsethesameseriesofbuttonpressesusedtodisabletheLEDtorestore