Jasco ZigBee ZB4001 - Advanced Control and Operation; Three;Four-Way Control Wiring; Basic Operation Modes

OPTIONALforTHREEorFOUR‐WAYCONTROL:
ConnecttheTravelerwire(usuallyRed)tothescrewterminalmarkedTRAVELERontheprimaryswitch
(DoNotremovethetapeovertheterminalifyouarenotusingthetravelerconnection).Theotherend
ofthisTravelerwireconnectstotheTRAVELERscrewterminalontheAuxiliarySwitch.
1. Theauxiliaryrequiresthefollowing3 wiringconnections:
a. TheTravelerwire.This isusedtosendvoltagesignalstotheprimaryswitch.Thesignalstellthe
switchwhatactiontoperform.
b. Ground.
c. Neutral.
2. DONOTconnecttheauxiliaryswitchtothehome’sblackHot(Line)wire.
Oncetheswitchisproperlywired,youshouldbeabletousetherockertomanuallyturnOn/Offthe
connectedload
BasicOperation
TheconnectedlightcanbeturnedON/OFFin two ways:
1. Manuallyfromthefrontpanelofthein‐wallswitch
2. RemotelywithaZigBeeController
MANUALCONTROL
TheFrontPanelRockerSwitchallowstheuserto:
TurnON/OFFtheconnectedlighting.
• ToturntheconnectedlightingON:Tapthetopoftherocker.
• ToturntheconnectedlightingOFF:Tapthebottomoftherocker.
REMOTECONTROL
ZigBeedevicescanbecontrolleddirectlybyyourZigBeeControllerandremotelyoverlongdistances
withaPCormobilephoneappifyourhome’scontrollerfunctionsasagatewayconnectedtoan
internetrouter.
TocontrolthedeviceremotelyitmustbepairedtotheZigBeeControllerasinstructed