Jasco ZigBee ZB4001 User Manual


.
ObserveImportantWiringInformation
Important:Thisswitchisratedforandintendedtoonlybeusedwithcopperwire.
Thehome’selectricalwiresmaybeattachedtothescrewterminalsorinsertedintotheholesinthe
backoftheswitchenclosureandclampedinplacebytighteningthescrewterminals.
Alwaysfollowthe
recommendedwirestriplengthswhenmakingwiringconnections.

Wiregaugerequirements
•Use14AWGorlargerwiressuitableforatleast80°Cforsupply(HOT),Load,Neutral,Groundand
Travelerconnections.

Wirestriplength:
•Forattachmenttoscrewterminals:Stripinsulation1in(25mm)
•Forattachmentusingtheenclosure’sholes:Stripinsulation5/8”(16mm)

ULspecifiesthatthetighteningtorqueforthescrewsis14Kgf‐cm(12lbf‐in).


SINGLESWITCHWIRING

1.Shutoffpowertothecircuitatfuseboxorcircuitbreaker.
2.Removewallplate.
!Warning:Verify
powerisOFFtoswitchboxbeforecontinuing.
3.Removetheswitchmountingscrews.
4.Carefullyremovetheswitchfromtheswitchbox.DONOTdisconnectthewires.
5.Therearefivescrewterminalsontheswitch;thesearemarked
 LINE(Hot)
 Neutral
 LOAD
 GROUND
 TRAVELER

TheTravelerterminalisonlyusedfor3‐wayor4‐waywiringandshouldremaininsulatediftheswitchis
beinginstalledina2‐waysystem(oneswitch&oneload).Matchthesescrewterminalstothewires
connectedtotheexistingswitch.
6.Disconnectthewiresfrom
theexistingswitch.
7.ConnectthegreenorbarecoppergroundwiretotheGROUNDterminal.
8.ConnecttheblackwirethatgoestothelighttotheterminalmarkedLOAD.
9.Connecttheblackwirethatcomesfromtheelectricalservicepanel(Hot)totheterminalmarked
LINE.
10.Connect
thewhitewiretotheneutral terminal.
Note:ULspecifiesthatthetighteningtorqueforthescrewsis14Kgf‐cm(12lbf‐in).
11.InsertSwitchintotheswitchboxbeingcarefulnottopinchorcrushwires.
12.Securetheswitchtotheboxusingthesuppliedscrews.
13.Mountthewallplate.
14.Reapplypowertothecircuitatfuseboxorcircuitbreakerandtestthesystem.



Jasco ZigBee ZB4001 Specifications

Power

power	120VAC, 60Hz

Signal

signal frequency	2.4 Ghz IEEE 802.15.4

Maximum Load

maximum load incandescent	900W
maximum load motor	½ HP
maximum load resistive	12 Amp, 1440W

Operating Environment

operating temperature range	32‐104° F (0‐40° C)
indoor use only	true