11
CONTROLS
Front view Jasic MIG 160C, 200C and 200PFC
1. Overheang LED
2. Power LED
3. MMA current control dial
4. "-" Output terminal
5. Euro outlet for MIG torch
6. "+" Output terminal
7. Wire feed control dial
8. Voltage control dial
9. MIG/MMA mode selector switch
Rear view Jasic MIG 160C, 200C and 200PFC
10. Power switch: The ON/OFF mains switch for the machine
11. Gas inlet connecon: The gas inlet that allows you to
connect the gas supply from the gas regulator
12. Cooling fans: The entry for the air to access the cooling
fans
13. Input cable gland: The entry for the mains power cable
To Next Page
Loading...
