Jasic MIG 350 Pulse Separate - Fire and Explosion Prevention; Noise and Moving Parts Safety; Magnetic Field Risks

WWW.JASIC.CO.UK 4
proper shade of lter lens to protect your face and
eyes when welding or watching.
Wear approved safety glasses with side shields
under your helmet.
Never use broken or faulty welding helmets.
Always ensure there are adequate protecve
screens or barriers to protect others from ash,
glare and sparks from the welding area. Ensure
that there are adequate warnings that welding or
cung is taking place.
Wear suitable protecve ame resistant clothing.
The sparks and spaer from welding, hot work
pieces, and hot equipment can cause res and
burns
Welding on closed containers, such as tanks,
drums, or pipes, can cause them to explode.
Accidental contact of electrode to metal objects
can cause arcs, explosion, overheang, or re.
Check and be sure the area is safe and clear of
inammable material before carrying out any
welding.
Protecon against noise
Some welding and cung operaons may
produce noise.
Wear safety ear protecon to protect your
hearing.
Protecon from moving parts
When the machine is in operaon keep away from
moving parts such as motors and fans. Moving
parts, such as the fan, may cut ngers and hands
and snag garments.
Protecons and coverings may be removed for
maintenance and controls only by qualied
personnel, aer rst disconnecng the power
supply cable.
Replace the coverings and protecons and close
all doors when the intervenon is nished, and
before starng the equipment.
Take care to avoid geng ngers trapped when
loading and feeding wire during set up and
operaon.
When feeding wire be careful to avoid poinng it
at other people or toward your body.
Always ensure machine covers and protecve
devices are in operaon.
Precauons against re and explosion
Avoid causing res due to sparks and hot waste or
molten metal
Ensure that appropriate re safety devices are
available near the cung / welding area.
Remove all ammable and combusble materials
from the cung / welding zone and surrounding
areas
Do not cut/weld fuel and lubricant containers,
even if empty.
These must be carefully cleaned before they can
be cut/ welded.
Always allow the cut/welded material to cool
before touching it or placing it in contact with
combusble or ammable material.
Do not work in atmospheres with high
concentraons of combusble fumes, ammable
gases and dust.
Always check the work area half an hour aer
cung to make sure that no res have begun.
Risks due to magnec elds
The magnec elds created by high currents may
aect the operaon of pacemakers or
electronically controlled medical equipment.
Wearers of vital electronic equipment should
consult their physician before beginning any arc
welding, cung, gouging or spot welding
operaons.
Do not go near welding equipment with any
sensive electronic equipment as the magnec
elds may cause damage.