Jasic MIG 350 Pulse Separate - Regulatory Compliance; RF Declaration; LF Declaration; Operational Safety and Disposal

WWW.JASIC.CO.UK 5
RF Declaraon
Equipment that complies with direcve
2004/108/EC concerning electromagnec
compability (EMC) and the technical
requirements of EN60974-10 is designed for use
in industrial buildings and not those for domesc
use where electricity is provided via the low
voltage public distribuon system. Dicules may
arise in assuring class A electromagnec
compability for systems installed in domesc
locaons due to conducted and radiated
emissions.
In the case of electromagnec problems, it is the
responsibility of the user to resolve the situaon.
It may be necessary to shield the equipment and
t suitable lters on the mains supply.
LF Declaraon
Consult the data plate on the equipment for the
power supply requirements.
Due to the elevated absorbance of the primary
current from the power supply network, high
power systems aect the quality of power
provided by the network. Consequently,
connecon restricons or maximum impedance
requirements permied by the network at the
public network connecon point must be applied
to these systems.
In this case the installer or the user is responsible
for ensuring the equipment can be connected,
consulng the electricity provider if necessary.
Materials and their disposal
The equipment is manufactured with materials,
which do not contain any toxic or poisonous
materials dangerous to the operator.
When the equipment is scrapped, it should be
dismantled separang components according to
the type of materials.
Do not dispose of the equipment with normal
waste. The European Direcve 2002/96/EC on
Waste Electrical and Electronic Equipment states
the electrical equipment that has reached its end
of life must be collected separately and returned
to an environmentally compable recycling
facility.
Handling of Compressed gas cylinders and
regulators
All cylinders and pressure regulators used in
welding operaons should be handled with care.
Never allow the electrode, electrode holder or
any other electrically “hot” parts to touch a
cylinder.
Keep your head and face away from the cylinder
valve outlet when opening the cylinder valve.
Always secure the cylinder safely
Never deface or alter any cylinder