Controls
4
Front view
1. Overheating LED to indicate overheating.
2. Power LED to indicate the power is on.
3. Downslope time control: 1~10s.
4. Post-flow time control: 1~10s.
5. "+" output terminal: To connect the work clamp.
6. "-" output terminal: To connect the TIG torch.
7. Torch switch plug connection.
8. Gas terminal: To connect the gas hose of the TIG torch.
9. 2T/4T switch: When the toggle switch is switched to 4T, self-lock function is
available.
10. MMA/TIG selector switch.
11. Welding current adjustment knob.
12. Handle
Rear view
13$ Power switch
14$ Warning label
15$ Input cable gland
16$ Cooling fan
17$ Gas inlet
7
To Next Page
Loading...
