Why does the electrode holder become very hot on my Jasic TIG180?
If your Jasic Welding System's electrode holder gets very hot, it's likely because the holder's rated current is less than the actual current it's handling. The solution is to replace it with an electrode holder that has a higher rated current capacity.
What to do if Jasic TIG180 Welding System shows over current LED?
If your Jasic Welding System shows a no-load voltage of “0” and the over current LED is on, it indicates an over current issue or damage to the power components. Try restarting the machine. If the problem continues, it's recommended to contact the service center of your distributor.
What to do if Jasic TIG180 shows under voltage LED?
If your Jasic Welding System is showing a no-load voltage of “0” and the under voltage LED is illuminated, it could be due to low mains voltage or auxiliary power failure. Welding can be resumed once the mains voltage returns to the appropriate level. If the auxiliary power has failed, replace the faulty circuit board.
What to do if Jasic TIG180 shows overheating LED?
If your Jasic Welding System shows a no-load voltage of “0” and the overheating LED is on, it means the overheating protection is active. The system should recover automatically once the welding machine has cooled down.
Why no arc can be started on Jasic Welding System?
If you're having trouble starting an arc with your Jasic Welding System, make sure that the mains power supply cable is properly connected. Also, check for and resolve any phase failure issues in the mains power supply.
How to fix difficult arc ignition on Jasic TIG180?
If you're finding it difficult to ignite the arc on your Jasic Welding System, it might be because the arc ignition current is too low, or the arc starting time is too short. Try increasing the arc ignition current or extending the arc starting time.
What to do if electrode sticking on Jasic Welding System?
If the electrode is sticking during welding with your Jasic Welding System, the arc force current might be too low. Try increasing the arc force current.
Ensure proper installation, grounding, and avoid touching live parts.
Ensure ventilation, use respirators, and be aware of fume reactions.
Wear protective gear, use screens, and avoid flammable materials.
Remove flammables, avoid welding containers, check work area after.
Caution for pacemaker users and sensitive electronics.
Emphasizes careful handling and avoiding contact with electrical parts.
Details features like hot start, 2T/4T, downslope, and arc force.
Highlights IGBT technology, efficiency, and low noise operation.
Identifies LEDs, controls, and terminals on the front panel.
Identifies power switch, warning label, and inlets on the rear panel.
Guides on checking for damage, retaining packaging, and selecting a suitable environment.
Details on power supply connection, grounding, and output terminal usage.
Explains polarity for MMA/TIG and specific connection for TIG torch.
Steps for MMA welding, including amperage selection and polarity.
Procedures for TIG welding, gas setup, and current adjustment.
Explains trigger functions and optional upslope time adjustment.
Lists electrode types and their relation to gas nozzle diameters.
Details workpiece thickness, joint form, electrode, wire, gas flow, current, and speed.
Outlines daily, monthly, and yearly inspection and cleaning tasks.
Lists common malfunctions, their causes, and solutions.
General| Brand | Jasic |
|---|---|
| Model | TIG180 |
| Category | Welding System |
| Language | English |
To Next Page